[CDJ-700] Virtual DJ Setup Guide

Please download the Gemini ASIO Drivers from our website.

Launch Virtual DJ.

Connect the power cable and USB cable to the rear of the unit.

Connect the USB cable to an available USB input on your computer.

Power on the CDJ-700.

The unit will be in CD mode by default.

With Virtual DJ open, press the MIDI button on the CDJ-700.

The unit will begin connecting to your computer.

At this point, it will begin installing the necessary drivers.  NOTE (Do not power off of disconnect the unit during this process)

Once drivers are installed and Virtual DJ recognizes your controller…You will see the following notification below…

Once drivers are installed and Virtual DJ recognizes your controller…You will see the following notification below…

Your unit is now paired up with Virtual DJ and your PC…

 Please mirror image the following screenshots below for a signal unit…

If you are using more than one CDJ-700 it will also be located here. You may use up to 4 decks.

Deck 2 and so on will then be available. All must be routed to Gemini ASIO under sound card and assigned to the proper channels. The channels must match up to the channels assigned in the Gemini ASIO Settings dialog box which can be accessed by clicking the ASIO button for any device under sound card. You will then see the following dialog box below…

Ex. Deck 1 is assigned to channels 1 & 2 ….. Deck 2 would be assigned to channels 3 & 4 and so on… Everything simply has to match.

*NOTE (When using more than 1 CDJ-700, you must MIDI connect them separately).  If multiple units are connected at the same time this will confuse VDJ.

 

Further Technical Support

Whether you are a customer or dealer, if you already own a Gemini product, or if you just have pre-sales questions, the Gemini technical support team is available to help! Visit the link below to connect with any of the following support options: phone support, email support. 

www.geminisound.com/support